Checking The Manual Drive (Chain); Checking The Electric Drive Components - Cube CARGO HYBRID 2020 Originalbetriebsanleitung

4. Check the brake disc for damage:
There must be no notches, chippings, deep
scratches or other mechanical damage and the
brake disc must be of the optimum thickness.
Bild:
Information on the minimum thickness on
the brake disc (1.8 mm)
5. Lift the front and rear wheels and turn them
by hand:
The brake disc must not have any lateral
runout.
6. Have the wear on the brake pads and the
brake disc checked by your specialist bicycle
dealer (see chapter 16 "Handover checklist"):
The brake disc must not fall below the min-
imum thickness. The minimum thickness
can be found in the enclosed component
instructions of the brake manufacturer.
7. Check your brake discs for dirt, especially
oil and grease.
Dirty brake discs must be cleaned
immediately.
During multi-day trips, the brake disc,
brake blocks and brake pads can wear
heavily.
Accordingly, replacement brake pads
and replacement brake pads can be
helpful on such trips.
Only carry out the replacement
Î
yourself if you are familiar with this
work. For more information, consult
your specialist bicycle dealer.
If you are not able to carry out the
Î
replacement yourself, have it carried
out by your bicycle specialist.
CARGO HYBRID
6.10 Checking the manual drive
(chain)
1. Check the chain ring for concentricity without
lateral movements while standing.
The chain rings and sprockets must not have
any lateral runout and there must be no foreign
bodies between the individual chain rings/
sprockets. Remove foreign bodies if this is
easily possible.
2. Check the chain for damage.
The chain must not be damaged at any point
by e.g. bent chain plates, protruding rivet pins,
etc. or have fixed, immovable chain links.
3. Check that the chain runs smoothly over the
shifting rollers and does not jump.
4. Have the chain wear checked by a specialist
bicycle dealer using a suitable measuring tool.
Bild: Chain wear gauge
6.11 Checking the electric drive
components
Observe the separate original instruc-
tions for the electric drive: In it, you
will find all detailed information of the
component manufacturer.
Perform a visual inspection of the electric
Î
drive components.
Check whether any components show visible
damage.
Refer to the original instructions for the electric
Î
drive to find out about the necessary test
steps for the components of the electric drive.
| 31