MC Crypt MIDI-7 Bedienungsanleitung Seite 27

6. Operating Elements
27. Play button
Play the music loaded on the deck.
28. Pause button
Pause the music playing on the deck.
29. "CUE" button
Returns and pauses the music at the last hot cue point. Refer to the "HOT CUE" button (22) to set a cue point. Alternatively, you may set it by
pausing the song, seeking the desired position, and then pressing on the "Cue" button. Then the last selected cue point will be repositioned.
A right-click on the "Cue" button in the computer interface will set a cue point while the track is playing. Once on the cue point, pressing and
holding down "Cue" will temporarily play this point. To delete a cue point, right-click on its icon on the Waveform display, and select "delete".
You cannot remove a cue point if you are using the mixer standalone (without using a computer software).
30. PC / LINE button
Press the button to switch the input source of the channel to PC / LINE.
31. Pre-fader level button
If the PFL button is pressed, the program sends the pre-fader level of the audio source to the cue section for headphone monitoring.
32. Touch jog wheel sensor LED
Lights when the touch jog wheel is touched.
33. "SCRATCH" button
Press to turn on / off the scratch function of the touch jog wheel. Noted that the touch jog wheel cannot be used for scratching and searching
at the same time.
34. "SEARCH" button
Press to turn on / off the searching function of the touch jog wheel. With the search function, you can go to a specific point in the music on the
deck easily by turning the touch jog wheel.
35. Sampler play button
Press to play the selected sampler. The sampler drop down box in the computer interface lights up green when the sampler is playing. To stop
playing it, click the sampler drop-down box in the computer interface. The drop-down box will be dimmed and the sampler will stop.
36. Sampler volume adjusting knob
Adjust the gain level of the selected sampler.
37. Sampler selection knob
Select a sampler. The corresponding sampler display LED lights when the sampler is being selected. The name of the sampler is also shown
in the computer interface.
38. Sampler display LED
The maximum number of samplers stored in the system is 12. The corresponding sampler display LED lights when the sampler is being selected.
39. Effect parameter 2 adjustment knob
Adjust the second parameter (if any) of the selected effect.
24