MC Crypt MIDI-7 Bedienungsanleitung Seite 26

6. Operating Elements
14. "LOOP OUT" button
Mark the end point of a loop and start looping. Press it again to quit the loop.
15. Loop shift button (lengthen)
Double the loop length - the maximum length of a loop is 32 CBG.
16. Master volume knob
Control the overall output signal volume. Turn it clockwise to increase the volume, turn it anti-clockwise to reduce the volume.
17. "MASTER TEMPO" button
When the button is pressed, the keylock function is enabled. The pitch of the song does not change the tone of the track. Keylock can be
enabled at any point along the pitch range to maintain the desired tone at that pitch while still being able to further adjust the pitch. When
disabled, the tone changes based on the pitch used, so slower pitch = slower deeper tone, and faster pitch = faster higher sounding tone.
18. "PITCH" button
The pitch button allows you to change the adjustable pitch range from ±6 % to ±100 %.
19. Pitch slider
Adjust the pitch within the pitch ranged.
20. "BEND +" button
21. "BEND -" button
The two pitch buttons are used to temporarily change the speed of the track playing. This is useful when you want to make a quick adjustment
to a track if the beat of the track is not exactly matching up with the beat of the track playing on the other deck. The speed will be affected as
long as you are pressing down "Bend +" or "Bend -".
22. "HOT CUE" buttons
Use the three buttons to set cue points. The first time you press on one of these buttons, a cue point will be set. At any time press on the
corresponding button and the track jumps back to that cue point. To set a new cue point for the hot cue, right-click the corresponding hot cue
button in the computer interface. If you want to delete a cue point, right-click on its icon in the waveform display of the computer interface,
and select "delete". Lock Image shows that the Smart Cue feature is activated. When smart cue is activated, songs are automatically re-
synchronized when jumped to a new position or cue.
You cannot remove a cue point if you are using the mixer standalone (without using a computer software).
23. Touch jog wheel
The touch jog wheel is used for scratching or searching.
24. Power LED
Lights up when the DJ controller is on.
25. Cross fader
The cross fader is used to cross-fade between the channels CH1 and CH2, i.e. one channel is faded out (becomes quieter) while the other
channel is faded in (becomes louder).
When the cross fader is in the middle position, channels CH1 and CH2 are played at the same volume.
26. Channel fader
These vertical faders allow you to adjust the audio signal of the individual channel.
23