Hob - Daily Use; Lighting The Burners; Turning The Burner Off - Electrolux EKK6450AO Benutzerinformation

5. HOB - DAILY USE

Downloaded from www.Manualslib.com
1.
Set the function
temperature.
2. Let the appliance operate for one
hour.
3.
Set the function
temperature.
4. Let the appliance operate for ten mi-
nutes.
WARNING!
Refer to the Safety chapters.

5.1 Lighting the burners

WARNING!
Be very careful when you use
open fire in a kitchen environment.
The manufacturer declines all re-
sponsibility in case of misuse of
the flame.
Always light the burner before you
put cookware on it.
1. Push the knob fully down and turn it
to the maximum position
you push the knob, the spark genera-
tor activates automatically.
2. Keep the control knob pushed for ap-
proximately 10 seconds. This lets the
thermocouple warm up. If not, the
gas supply is interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does
not light, check if the crown and
its cap are in the correct positions.
manuals search engine
5.
and the maximum
6.
Accessories can become hotter than usu-
and the maximum
ally. The appliance can emit an odour and
smoke. This is normal. Make sure that the
airflow is sufficient.
A)
B)
C)
D)
. When

5.2 Turning the burner off

A
To put the flame out, turn the knob to the
symbol
B
C
D
Set the function and the maximum
temperature.
Let the appliance operate for ten mi-
nutes.
Burner cap
Burner crown
Ignition candle
Thermocouple
WARNING!
If the burner does not light after
10 seconds, release the knob and
turn it to the off position. Wait for
1 minute before you try to light the
burner again.
You can light the burner without
electrical devices (e.g. when there
is no electricity in the kitchen). To
do so, put the flame near the
burner, push the knob down for
10 seconds and turn it to the
maximum gas release position.
If the burner accidentally goes out,
turn the knob to the off position.
Wait for 1 minute before you try to
light the burner again.
The spark generator can start au-
tomatically when you switch on
the mains, after the installation or
a power cut. It is normal.
.
WARNING!
Always turn the flame down or
turn the burner off before you re-
move the pans from the burner.
ENGLISH 9