Intended Use; Misuse; Operator Obligations; Personnel Qualification - HallermannTyton AT2000 CPK Betriebsanleitung

2 .5 Intended use

The may only be operated in
overhead suspension
perfect and safe condition, while keeping safety and
potential dangers in mind.
The with integrated tool is suitable
overhead suspension
and intended for the following applications:
• Automatic tying up the cable bundle up to
max. 20 mm diameter
• For indoor use only
• Industrial use

2 .6 Misuse

Any use that is not mentioned in the "Intended use"
section is considered as misuse. The operator of the
overhead suspension bears sole liability for any
resulting damage.
In addition to that, the safety regulations of the tool
also apply
à Operating instructions for Autotool 2000 CPK
In particular, the following use is not permitted:
• Use with defective parts
• Use in explosive or inflammable environments
• Outdoor use
• Use with high humidity and / or direct solar radiation
• Manual interventions while the process is running
• Unauthorised changes and modifications on the
overhead suspension or the tool and their
components without approval by HellermannTyton
• Use of spare parts and accessories that were not
tested and approved by HellermannTyton
• Installation on an unsuitable ceiling, supporting
structure, and/or rail system
• Installation of unauthorised tools, objects, and/or
persons on the overhead suspension

2 .7 Operator obligations

The operator must:
• observe and comply with the respectively applicable
national accident prevention regulations and health
and safety regulations.
• provide the qualified personnel with the required
protective equipment and check, maintain and replace
damaged parts according to the regulations.

2 .8 Personnel qualification

Underage persons of trainees may only perform work
under the supervision of an experienced qualified
personnel and with the express consent of the
operator.
Operating Instructions • Overhead Suspension AT2000 CPK • 03/2020 • 106-29021

2 .8 .1 Qualified personnel for operation

The qualified personnel for advanced operation are
assigned with the following tasks and responsibilities:
• Operation of the tool and the overhead suspension
• Elimination of faults or initiation of measures to
eliminate faults
• Cleaning the tool and the overhead suspension
Due to their specialised training or practical
experience, this personnel ensures proper handling.
2 .8 .2 Qualified personnel for maintenance and
repairs
Maintenance and repairs may only be performed by
qualified personnel. Due to their specialised training,
this personnel has sufficient knowledge about the
tool or the overhead suspension and can assess its
safe working condition.
Moreover, the personnel is familiar with the following
rules and regulations:
• Relevant national health and safety regulations
• Accident prevention regulations
• Generally recognised rules of the technology,
provisions and standards

2 .8 .3 Trained electrician

Work on the electrical supply and on live components
may only be performed by a trained electrician.
2 .8 .4 Authorised qualified personnel for repairs
and inspection
Repairs and safety inspections may only be performed
by a service technician from HellermannTyton or a
service technician authorised by HellermannTyton.
Safety instructions
6