Clas Ohlson A1 Bedienungsanleitung Seite 3

Instructions for use
Charging
1. Connect the included charging cable to the Micro-B charging port on the speaker
and to a computer or other USB charger.
2. When the battery is charging the LED indicator will shine red. The LED indicator will
turn off once the battery is fully charged.
Switching On/Off
3 s
Hold down [
to turn the speaker on.
Connecting a Bluetooth device (pairing)
1. Make sure that the
speaker is switched off.
2. Hold down [ ] for
approximately 3
seconds until the
LED indicator flashes
blue. The speaker
is now detectable
for other Bluetooth
devices.
3. Activate Bluetooth on the device to be paired and begin scanning for the speaker.
When the speaker has been found by the Bluetooth device it will be displayed as A1.
4. Select the speaker from the list. The LED on the speaker will shine for approx: 1.5
seconds and then turn off for approximately: 1.5 seconds in play mode. In pause
mode it will shine all the time.
5. Start playback on your device. Control playback and adjust the volume using your
Bluetooth device.
• The speaker will automatically connect to the device it was connected to last
(provided that Bluetooth mode is activated on your device).
• If you want to connect another device, follow steps 1−5 above in the same way as before.
3 s
ON
] for 3 seconds Hold down [
to turn the speaker off.
3 s
3
Bluetooth
Devices
A1
OFF
2 s
] for 2 seconds
Bluetooth
Devices
A1
1h:30min
1h:30min