Mode Of Operation - HEYLO DT 860 Betriebsanleitung

The device has been specifically designed for use
on construction sites.
The device must only be operated:
– for the purpose for which it was intended,
– in compliance with the instructions in chapter
Safety [ 32].
Assembly, scope of delivery and
accessories
6
5
4
Fig. 13: Device, front
1 Operating panel
3 Base bracket
5 Power cable
EN
1
2
3
2 Housing with outlet
grille
4 Castors
6 Handle
Fig. 14:
Device, rear
1 Inlet air grille with
filter holder
3 Power meter
5 Connection for
discharge hose
The scope of delivery includes:
– Air dehumidifier
– Filter pad
– Operating manual
The following device accessories are available:
– Condensate pump

Mode of operation

The fan draws in humid room air through the inlet
opening. The air flows along the evaporator, where
it cools down. At the evaporator, moisture extract-
ed from the air accumulates in the form of con-
densate. After the room air has been fed along the
evaporator, it is heated in the condenser and
transferred as dry and warm air through the air
outlet to the room. The dried, warm air the ab-
sorbs more moisture from the room.
The condensate produced in the process is fed to
the condensate tank and eventually discharged or
Dehumidifier DT 860
1
2
3
4
5
6
2 Ambient sensor
4 Condensate tank
with float switch
6 Power cable
35 / 55