Cleaning And Maintenance - HEYLO DT 860 Betriebsanleitung

Problem / Possible cause / remedy
message
mains connection.
No conden- Filter clogged.
sate is col-
Check the filter; replace, if neces-
lected alt-
sary.
hough the
Evaporator failure/malfunction
device is
Contact the HEYLO Service De-
running.
partment.
Pump defective (only in devices
with condensate pump).
Contact HEYLO Technical Depart-
ment.
Pump sump clogged (only in de-
vices with condensate pump).
See Cleaning the pump sump
Air humidity or room temperature
too low.
Check the room conditions, using a
thermo hygrometer.
Device Device is not level and upright.
makes unu-
Check the operating conditions,
sual noise
particularly the installation site.
and vibrates,
condensate
escapes.
The device Air circulation obstructed.
heats up,
Ensure that the air can circulate
becomes
freely. Clean the air slits in the pro-
noisy and
tective cover. Check the air filter.
dehumidifies
poorly.
Tab. 8: Troubleshooting table
EN
18
The cleaning and maintenance, observe the fol-
lowing general rules:
– These tasks described below may only be car-
ried out by trained and authorised specialists.
a) Before starting work, switch off the device
and disconnect the power plug.
b) Wear suitable personal protective equipment.
c) Before restarting the device, install all safety
devices that might have been removed.
d) Test the safety devices to ensure that they
work properly.
e) After completing the task, remove all the tools
and objects from the working area around the
device.
[ 46].
DANGER
Danger to life due to electric shock
Touching electrically live parts can be fatal.
a) Switch off the device and pull out the mains
plug.
CAUTION
Danger from the device being unintention-
ally started up
Uncontrolled starting of the pump or the fan can
lead to injuries.
a) Switch off the device at the device switch
and pull out the mains plug.
Dehumidifier DT 860
Cleaning and
maintenance
43 / 55