Running And Operating The Device - HEYLO DT 860 Betriebsanleitung

Dehumidifier DT 860
– During dehumidifying, the air in the room is
heated. In small rooms, this can substantially
increase the room temperature.
As a rule, room temperature between 20 °C
and 27 °C provide the best conditions for ef-
ficient drying. The room temperature must not
exceed 38 °C or drop below 1 °C, as the de-
vice is otherwise unable to work properly (see
also Technical details
16 Running and operating
the device
CAUTION
Risk of infection
The condensate may be contaminated with path-
ogens.
a) Never drink the condensate.
b) Avoid leaving condensate in the collecting
vessel or in the condensate discharge hose
for a longer period of time. Regularly pump
off the condensate.
Attention
Damage to device from improper de-icing
During operation, the evaporator may become
iced up.
a) In this case, run the automatic defrosting
function.
b) Never attempt to remove the ice with a
sharp-edged implement.
Before switching on the device
a) Make sure that the device is not standing on a
wet surface, and that it is in a safe upright
position.
b) Check the power cable for defects.
40 / 55
[ 49]).
c) Ensure that the device is connected to a fused
socket of the correct voltage (see Technical
details [ 49]).
d) Make sure that the condensate can drain off
safely. Check whether the condensate tank is
inserted properly.
Place the free end of the condensate dis-
charge hose in a drain or in an empty collect-
ing container of suitable capacity.
e) If necessary, call up the operating hours
counter and document the current counter
reading (to reset the counter, see Control and
display elements [ 37]).
f) If necessary, read the kW/h value on the
power meter and document it.
Switching device on
Fig. 17:
Switching device on
1 ON/OFF indicator
3 FULL indicator
5 SET- button
a) Press the ON/OFF button.
 The ON/OFF indicator is lit in green.
 NOTICE! If the compressor is not yet
ready for operation, the WORK indicator
flashes.
 When the compressor is ready and the
WORK indicator no longer flashes, the de-
vice is automatically started.
 Press the SET + or SET – button to set the
required humidity level.
2 WORK indicator
4 SET+ button
6 ON/OFF button
EN