After Operation; Transport And Storage - Starmix GS 2450 Oil & Metal Bedienungsanleitung

en
ATTENTION
Disposal must comply with applicable disposal and/or hazardous material disposal laws.
ATTENTION
The viscous slime produced on cooling lubricants by microbacterial contamination should be disposed
of from the container separately. This is because the viscosity of this slime can seal the openings of
the shavings separation tray and prevent the passage or dripping of other liquids
Cleaning the dust container
The dust container must be cleaned at regular intervals:
1. Lower the dust container with the hand lever.
2. Loosen the screws of the clamps of the separation tray
3. Remove the separation tray at an angle
4. Remove the deposits and rinse
5. Rinse the 90° bend and the drain hose well
6. Reassemble in reverse order

After operation

After vacuuming up media other than clean water (e.g. liquid containing lime, bitumen or concrete), rinse the
vacuum cleaner with clean water after use.
1. Vacuum up clean water (e.g. from a bucket),
2. switch off the vacuum cleaner, disconnect the power plug.
3. Empty and dry the container completely.
4. Wind up the power supply cable and suction hose.

Transport and storage

1. Close the locks on the lid before transport.
2. Take the weight of the vacuum cleaner into account, especially when the dust container is full.
3. Do not tilt the vacuum cleaner if there is liquid in the dust container.
4. Store the vacuum cleaner indoors in a dry place and protected from frost.
20
Model variant
1)