Specifications - Makita DFT022F Betriebsanleitung

ENGLISH
(Original instructions)
1 Red indicator
2 Button
3 Battery cartridge
4 Indicator lamps
5 Check button
6 Switch trigger
7 Reversing switch lever

SPECIFICATIONS

Model
Fastening torque
No load speed (min
Dimensions (L x W x H)
(with BL1430 battery)
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
General Power Tool Safety Warnings
WARNING Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
Explanation of general view
8 Front lamp
9 LED indicator
10 Adjust grip
11 Ring
12 Adjust ring
13 Scale
14 Hole for adjust grip
DFT022F
Hard joint 0.5 – 2 N·m
Soft joint 0.5 – 2 N·m
–1
)
BL1415N / BL1415NA / BL1430 / BL1430B / BL1440 / BL1450 /
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
ENE033-1
GEA010-2
DFT044F
1 – 4 N·m
1 – 4 N·m
700 950
200 mm x 74 mm x 250 mm
1.3 – 1.7 kg
D.C. 14.4 V
BL1460A / BL1460B
CORDLESS SCREWDRIVER SAFETY
WARNINGS
1. Hold the power tool by insulated gripping
surfaces, when performing an operation where
the fastener
Fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch
immediately after operation; they may be
extremely hot and could burn your skin.
6. Always secure workpiece in a vise or similar
hold-down device.
SAVE THESE INSTRUCTIONS.
15 Yellow line
16 Compression spring
17 Bit
18 Sleeve
19 Limit mark
20 Brush holder cap
21 Screwdriver
DFT084F DFT126F
3 – 8 N·m 5 – 12 N·m
3 – 8 N·m 5 – 12 N·m
780
may contact hidden
the bit or the
410
GEB139-1
wiring.
workpiece