Programming Instructions; Programming The Clock; Adjusting The Time - Hobby biotherm pro Gebrauchsanweisung

5. Programming instructions

g g
To activate program mode, press the
The ▲ and ▼ buttons are used to switch between the various programming main levels: Clock –Temperature 1 –
Temperature 2 – Timer.
To exit program mode from main level, press and hold the
for 90 seconds. To switch from sub to main level as well hold the

5.1 Programming the clock

5.1.1 Adjusting the time

j g
The clock symbol flashes when program mode is active.
button, the hours will flash – "12".
Press the
Use the ▲ and ▼ buttons to set the hours between 0 and 23.
button, the minutes digits "00" will flash.
Press the
Use the ▲ and ▼ buttons to set the minutes between 0 and 59.
button, the seconds will flash - "00".
Press the
Use the ▲ and ▼ buttons to set the seconds between 0 and 59.
Note: Once the clock has been set at least once, you can use ▲ or ▼ to directly access the settings "TEMP1",
"TEMP2" or "TIME".
Attention: The Biotherm pro system does not automatically switch between summer time and winter time. This chan-
ge must be entered manually.
8
button.
button for 3 seconds or do not press any buttons
button for 3 seconds.