Display; Safety Instructions; Assembly - Hobby biotherm pro Gebrauchsanweisung

1.2 Display

= Clock symbol, flashes when entering the settings for time of day
= Time digits, indicate the time and are used for setting program times
= Alert symbol, flashes in the event of an alert
= Symbol for temperature control range 1 (water heating)
= Numerical display for temperature/ time
= Symbol for temperature control range 2 (floor heating/cooler)
= Symbol for time control range
= Symbol for programming desired values
= Symbol for Heating mode
= Symbol for Cooling mode
= Degree Celsius, unit for temperature control

1.3 Safety instructions

The Biotherm pro system is only designed for use in enclosed rooms. All electronic components of the Biotherms pro
unit must only be operated whilst they are free from defects. Should the mains supply be damaged, please call in a
qualified specialist to replace it or send the device away to be repaired. Continued operation of the device may cause
fatal injury due to electric shock. Ensure that the control unit (
with water. Always disconnect all electrical devices from mains when you reach into the aquarium with your hand.
Technical products must only be operated as supplied. Electronic components must not be modified in any way, and
the leads must not be shortened. Covers or housings must not be opened. The product must not be used if damaged
or must be shut down immediately by pulling the mains plug if damage is detected.
Hint: It is advisable to use ground fault circuit breakers for all devices on the aquarium. All devices downstream of the
circuit breaker are then disconnected from the mains supply in the event of a short circuit.

1.4 Assembly

Control unit
The rear side of the control unit (
fixed to the wall or the aquarium cabinet with the screw set (
USB connector so that holes of control unit dimensions do not need to be sawn out of the aquarium cabinet. The USB
connector is not designed for a computer connection. The control unit has a cable length of 2 metres which permits
installation outside the aquarium cabinet as well as an unobstructed view of all values and status modes.
Connection strip
The connection strip (
there is no contact with the unit in the event of water leaking from the aquarium.
4
) is equipped with recesses that are used to lock the fastening rail (
) should be screwed to the back or side panel inside the aquarium cabinet to ensure that
) and connection strip (
). The cable to the control unit is equipped with a
) cannot come into contact
) which is