Causes Of Error; Technical Data; Eu Declaration Of Conformity - Hobby biotherm pro Gebrauchsanweisung

7. Causes of error

In the event of a claims issue, please perform a reset to factory settings in the first instance. If this does not eliminate
the fault or error, please identify the fault using the table below:
Error
Display indication E1 Cable break temperature sensor
Display indication E3 Error in time settings for temperature control
In the event of a warranty or repair issue, please contact:
Dohse Aquaristik KG
Service department
Reiner Borghold
Industriestrasse 6
D- 33758 Schloß Holte – Stukenbrock
Tel: +49 52 07 - 92 999 10
e-mail: reiner.borghold@dohse-aquaristik.de

8. Technical data

Operating voltage:
Connected load for each slot:
Total connected load of the connection strip:
Temperature display range:
Temperature 1 control range:
Temperature 2 (differential to temperature 1):
Temperature alarm range:
Temperature display accuracy:
Temperature control accuracy:
Connecting cable length:
Sensor cable length:
Cable control unit - control strip length:

9. EU declaration of conformity

The manufacturer declares that the devices comply with the requirements of the relevant EMC and LVD standards and
are therefore in conformity with EC directives 2004/108/EC and 2006/95/EC.
14
Possible cause
on slot 1
230 V 50 Hz
Max. 2,000 W (ohmic load)
Max. 3,000 W (ohmic load)
-9.9 – 99.9° C
10.0 – 40.0° C
Control range 0.1-5.0° C
1 – 5.0° C (00 means 'no alarm')
0.1° C
0.2° C
1.5 m
3 m
2 m
Solution
Send device in for repair
Ensure that the programmed times do not
overlap