Deactivation/Activation Of The Audible Temperature 1 (Water Heating) Alarm; Programming Of Temperature 2 For Slot 2 (Floor Heating/Cooler); Choice Of Heat /Cool; Adjusting The Temperature 2 (Floor Heating/Cooler) - Hobby biotherm pro Gebrauchsanweisung

5.2.3 Deactivation/Activation of the audible temperature 1 (water heating) alarm

When "OFF" is flashing, use the ▲ and ▼ buttons to activate the alarm with "ON" or to deactivate it by selecting
"OFF". Press
. "TEMP 2" is flashing.
5.3 Programming of temperature 2 for slot 2 (floor heating/cooler)

5.3.1 Choice of HEAT /COOL

. (To set the timer control (alternative to temperature control), press ▼
To set the temperature 2 regulation, press
until TIME flashes, then press and continue with item 5.4 of these instructions)
Flashing " ".
) operating mode (control of connected Heaters) or use ▲ and ▼ to select
Confirm with to select HEAT (
COOL ( ) (control of connected Cooling devices).
5.3.2 Adjusting the temperature 2 (floor heating/cooler)
When "0,1" is flashing, press
to set the differential of floor to water temperature.
Use ▲ and ▼ to set a differential between 0.1° and 5.0° C. (0,0=Slot 2 not active).
If you want to finish programming, press and hold for 3 seconds until the display returns to operating mode.
ATTENTION, pressing only briefly will take you to the timer control setting (alternative option to temperature
control) for slot 2. The programmed values for temperature control are deleted the moment the program mode for
timer control is opened.
10