Pelgrim IDK826 Anleitung Seite 54

A A
1. Check if the kitchen cabinet and the cut out
are in accordance with the instructions
(see 'safety' and 'building in dimensions').
2. Remove the protective foil from the sealing
strip and affix the strip (A) in the groove of
the aluminium profiles or on the edge of the
glass plate. Do not affix the sealing strip
round the corner but instead cut 4 pieces
that fit tightly together in the corner.
3. If the woodtop is made of treated wood,
then coat the sawn surfaces of the top with
sealing varnish, to prevent moisture
causing the top to swell.
4. Turn the appliance over and put it in the
cutout.
5. Connect the appliance to the mains supply.
The displays light up for approximately 30
seconds. This is normal!
6. Check its operation. If the appliance has
been connected incorrectly, it will emit a
beep signal or the displays will not
illuminate.
7. Hand over the instructions to your
customer.