Hendi 7000 Bedienungsanleitung Seite 7

Operation
• Select the front or rear hob that you want to use.
Place a suitable cooking equipment at the centre
of the heating surface. (front or rear hob)
(See --> Suitable cooking equipment).
Note: Do not place empty cookware as this may
damage the cookware.
• Then, connect the internal wires of the power
supply cord to a suitable electrical supply.
(See --> Power supply line connection).
• Switch on the electrical power supply system.
• "- - - -" will be shown on the display (2) and (3)
and the appliance is in STANDBY mode.
• After that, you can start to operate by turning the
knob (1) or (4) in clockwise direction depend on
which of the hob that you use (Front or rear hob).
• Power that you select will be shown instantly on
the display (2) or (3).
• Now, the appliance starts cooking operation. The
set power will be shown on the display (2) or (3)
during operation accordingly.
Error codes display
Error codes shown on
the display (2) or (3)
E 1
E 2
E 3
Cleaning and Maintenance
Attention: Always disconnect the appliance from the electrical power source and let it cool down completely
before cleaning and storage.
Cleaning
• Never immerse the appliance in water or other
liquids.
• Clean the cooled exterior surface with a slightly
damp cloth or sponge with some mild soap solution.
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
Possible cause
The temperature of the appliance is too
high
Cooling fan defective
The pan or pot is overheated.
Possibly, the pan becomes empty and
appliance will shut down for protection.
The supply voltage is abnormal. (Supply
voltage is too high or too low)
• After cooking finished, you can turn the appliance
to STANDBY mode by turning the knob (1) or (4) to
"0" position and "- - - -" is shown on the display
(2) or (3) respectively.
Note:
1). After an extended period of operation, it is nor-
mal for the cooling fan inside to continue run-
ning in STANDBY mode for some time. Before
unplug the appliance, wait until the cooling fan
stops running.
2). The appliance's surface is still hot even after
switch to STANDBY mode. Please wait the ap-
pliance completely cool down before touching
or cleaning.
3). Max power setting is 5000W for front hob and
3500W for rear hob respectively. When set the
front hob to 5000W, the max power of the rear
hob will then change to 2000W.
4). If no cookware is placed on the heating surface
during operation, it will switch off automatically
within 1 minute and beep sound will be heard.
Possible solution
Clear all obstacles that around the appliance. Dis-
connect the appliance, remove the pan or pot, wait
until the appliance is completely cool down.
Contact the supplier.
Disconnect the appliance, remove the pan or pot,
wait until the appliance is completely cool down.
And make sure water is inside the pan.
Make sure that the appliance is connected to a
suitable electrical power supply.
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
• Store the appliance in a cool, clean and dry place.
• Never put objects on the heating surface as it
may crack the surface.
EN
7