Hendi 7000 Bedienungsanleitung Seite 5

• Only use the cookware of the type and size recommended. (See ---> Suitable cooking
equipment).
• The power supply lines should be connected to the electrical power supply system by
authorized technician.
Intended use
• This appliance is intended for professional use.
• The appliance is designed only for cooking a vari-
ety of food via heating the suitable cookware. Any
other use may lead to damage to the appliance or
personal injury.
Grounding installation
This appliance is classified as protection class I
appliance and must be connected to a protective
ground. Grounding reduces the risk of electric
shock by providing an escape wire for the electric
Control panel of the appliance
1. Left turning knob :
2. Left digital display :
3. Right digital display : Display the power setting for front hob
4. Right turning knob : Switch ON / STANDBY and power setting for front hob
Preparations before using for the first time
• Remove all protective packaging and wrapping.
• Check to make sure the appliance is undamaged.
In case of incomplete delivery and damages.
Please contact supplier (See ==> Warranty).
• Clean the appliance before use (See ==> Cleaning
and Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and
heat resist surface that is safe against water
splashes.
Switch ON / STANDBY and power setting for rear hob
Display the power setting for rear hob
• Operating the appliance for any other purpose
shall be deemed as a misuse of the device. The
user shall be solely liable for improper use of the
device.
current. This appliance is equipped with a cord
having a grounding wire. The wires must be con-
nected to the electrical power source that is prop-
erly installed and grounded.
• Ensure that there is sufficient ventilation. Keep a
minimum distance of 15cm around the appliance
bottom of cookware
• Do not place the appliance in close proximity to
devices which are sensitive to disturbances by
magnetic sources (e.g. radios, tape decks).
Note: Due to manufacturing residues, the appli-
ance may emit a slight odor in the first few cycles.
This is normal and does not indicate any defect or
hazard. Make sure the appliance is well ventilated.
EN
5