Dometic 10 Serie Bedienungsanleitung Seite 36

Troubleshooting
Code Fault
E03 No connection between power
module and display
E07 No cooling capacity in gas mode
E08 No cooling power in AC mode
E09 No cooling power in DC mode
E12 Gas valve check error
E13 Internal communication error
E14 In stand-alone gas mode: The battery
charge of the battery packs is too low
E50 Gas lock after 3 ignition attempts
E51 Gas lock, internal error in the power
module
36
Solution
Contact an authorized customer service.
Check if the device is at an angle and adjust it
if necessary.
Reset the error.
Contact customer service if this error occurs
again.
Check if the device is at an angle and adjust it
if necessary.
Reset the error.
Contact customer service if this error occurs
again.
Check if the device is at an angle and adjust it
if necessary.
Reset the error.
Contact customer service if this error occurs
again.
Gas operation is not possible.
Reset the error.
Contact customer service if this error occurs
again.
Gas operation not possible.
Reset the error.
Contact customer service if this error occurs
again.
Insert new batteries and then reset the error.
Ignition not possible.
The gas cylinder is empty. Replace the gas cyl-
inder.
Reset the error.
Reset the error.
Contact customer service if this error occurs
again.
RMDT10
EN