System Tones - Honeywell Domonial Benutzerhandbuch

3- Understanding the system tones
E
N
SIRENS
G
A siren is an effective deterrent due to its power and very irritating tone.
The system has a siren built in the control panel. An optional remote
L
siren can be added.
I
In addition, the panel built-in siren emits an audible confirmation
tone when arming and disarming the security system and a fire
S
tone when a smoke detector is triggered. The volume levels can be
adjusted by the installer.
H

SYSTEM TONES

TOTAL SET
ARMING
PART SET
ARMING
ANNEX SET
ARMING
EXIT DELAY
ENTRY DELAY
DISARMING
FAULT
ALERT
Downloaded from www.Manualslib.com
Sequence of 3 modulated sounds
Duration : 4 seconds
Sequence of 2 modulated sounds
Duration : 2,5 seconds
Upon arming...
One beep per second
Upon entry...
One beep every second
Continuous beep
Duration : 2,5 seconds
2 times 7 fast beeps
4 beeps in case of alert...
sent via the keypad
manuals search engine
When arming total set, confirms that the
control panel has received a valid code or
TAG and is preparing to arm total set.
When arming the part set, confirms that
the control panel has received a valid
code or TAG and is preparing to arm part
set.
Beeps sound at the end of the exit time
until the system is armed.
After you open the entry door, the entry
time starts. You should disarm your
system within this time. Beeps sound at
the end of the entry time.
When Disarming, confirms that the
control panel has been successfully
disarmed.
This tone indicates a fault in the system.
Confirms the transmission of an alert to
the Alarm Receiving Centre.
- 4 -