Honeywell Domonial Benutzerhandbuch Seite 16

7- How to control your system over the phone
Control of your system over the phone is only possible from a multi-frequency
phone (tone dialling) or from your cellular phone. This function must be
configured by the installer.
The Domonial control panel picks up your call after the number of rings
configured by the installer or after it has been called twice successively.
To access your system:
• Dial the phone number of your security system .
A 2-second beep sounds followed by the "Arpeggio" invitation tune.
• Enter a valid code within 30 seconds.
A high-pitch beep confirms that the code is valid.
To arm your system:
• Dial * 21 to arm the total set, *22 to arm the part set, * 23 to arm the annex set.
To disarm your system*:
• Dial * 31 to disarm the total set, *32 to disarm the part set, *33 to disarm the annex set.
To control an electrical device**:
• Dial *101 to *112 based on the number of the equipment programmed in your alarm system.
• Dial 1 to turn on the device, 0 to turn it off.
To listen to the site and talk through the microphone of the control panel (if configured):
• Dial *6 to enter listening-in mode. You can immediately listen in to your house.
• Dial 1 to talk, and 0 to listen again.
To terminate the call:
• Dial * then #.
Access your system
Total set arming
Part set arming
Annex set arming
Control equipment
Audio verification
Terminate the call
* This function is not available on all product versions and depends on country regulations.
** This function requires an optional X10 extension with X10 modules.
Downloaded from www.Manualslib.com
Arming is confirmed as soon as you can hear a melody.
One short beep informs you that your equipment is active .
Two beeps inform you that your equipment is not active.
Your security system ends the call.
Call system + Enter CODE
*21
*22
*23
*101 - *112
*6
*#
manuals search engine
1: ON
1: TALK
- 15 -
0: OFF
0: LISTEN
E
N
G
L
I
S
H