Honeywell Domonial Benutzerhandbuch Seite 13

6- How to use the keyfob with 1 LED*
ARMING
Press the Total or Partial arm** button:
If a door or window equipped with contacts is left open, the system cannot be armed.
Always make sure that your arming request is followed by the tone.
DISARMING
To disarm, press the disarm button
Disarming will also stop the siren but it does not interrupt the transmission to the Alarm
Receiving Centre.
CALLING FOR ASSISTANCE (PERSONAL ATTACK)
These buttons enable you to call for assistance at any time.
Press the SOS buttons simultaneously:
The personal assistance function can be used even when your system is not armed.
f this has been set up by the installer, the siren stops automatically after 30 seconds, but you
can stop it manually by pressing the disarm button.
SPECIAL BUTTON
The action of the special button is dependent on your configuration.
As an assistance button it enables you to call for assistance. In this case, press the button,
pause until the indicator light comes on, then press again.
As a remote control for electrical appliances, press the button to turn each appliance on and
off successively.
* The system can include 0-4 keyfobs of this type.
** Provided that this function has been programmed by the installer, you can choose to protect only a part of your premises whilst
you are in the other part.
*** This function requires an optional X10 extension with X10 modules.
Downloaded from www.Manualslib.com
The indicator light on the keyfob comes on briefly when you release the
button.
The arming tone is emitted by the panel siren
The indicator light comes on briefly when you release the button.
The disarming tone is emitted by the panel siren.
The indicator light on the keyfob comes on briefly when you release
the button.
The siren is triggered (depending on the configuration).
The Alarm Receiving Centre is alerted.
manuals search engine
- 12 -
E
N
G
L
Total set arming I
S
Partial set arming
H
Disarming
+