Reel Multimedia ReelBox Serie Bedienungsanleitung Seite 36

Operation
With digital antennas (DVB-T),
you should adjust their position or
GB
install a stronger antenna.
With satellite systems, readjust the
damping for the individual outputs
at the multi-switch.
SNR = signal-to-noise ratio.
Should also be at least 60 % for a
stable reception.
BER = Number of repairable faults
within the stream received.
UNC = Number of irreparable
faults within the stream received.
These values are displayed as an
8-digit number that should ideally
be „00000000". If a value that is
greater than „000000xx" (BER) or
„00000000" (UNC) is displayed
here, then the reception signal is
disturbed too much.
34
In this case, contact your cable
service provider and check the
cables in your house for defects.
With digital antennas (DVB-T)
and satellite systems, check the
proper fit of the ZF cables at all
connection points as well as the
correct alignment of the antenna
or the satellite dish and your LNB.
To check all tuners for perfect
function, switch through the
button.
The currently active menu is
displayed in the upper menu line.
NetCeiver (blue button on FB)
All system and signal information
on the DVB platform NetCeiver
can be displayed here
(e.g. information on the
operating system or hardware,
series number, tuner slots, tuner
frequencies).