What To Do If - Zanussi ZKS851DX Benutzerinformation

What to do if ...

Problem/Display
The cooking zones cannot be switch-
ed on or are not operating
Display is switching between two
heat settings
The residual heat indicator is not dis-
playing anything
lights up
lights up
and number are displayed
Acoustic signal sounds when appli-
ance is switched off
Repeated acoustic signal (6x), appli-
ance switches off
12
Possible Cause
More than 10 seconds have passed
since the appliance was switched on
The lock is switched on
The child safety device is switched on Deactivate child safety device (see
Several sensor fields were touched at
the same time
Automatic switch-off has been trig-
gered
There is water on the control panel or
the control panel is covered with fat
splashes
STOP+GO is activated
Power management is reducing the
power of this cooking zone
The cooking zone was only on for a
short time and is therefore not hot
Unsuitable cookware
No cookware on the cooking zone
Diameter of the base of the cookware
is too small for the cooking zone
Automatic switch-off has been trig-
gered
Electronics fault
The control panel is wholly or partly
covered by objects.
One or more sensor fields have been
covered for longer than 10 seconds
Remedy
Switch the appliance on again.
Switch off the lock (See the section
"Locking/unlocking the control pan-
el")
the section "Child safety device")
Only touch one sensor field
Remove any objects (pans, etc.) that
are lying on the control panel. Switch
appliance on again
Wipe the control panel
Switch off STOP+GO
See the section "Switching the power
function on and off"
If the cooking zone is supposed to be
hot, call your local Service Force
Centre.
Use suitable cookware
Put cookware on zone
Move to smaller cooking zone Use
suitable cookware
Switch appliance off. Switch appli-
ance on again
Disconnect the appliance from the
electrical supply for a few minutes
(Take the fuse out of the house's wir-
ing system) If after switching on
again, is displayed again, call the
customer service department
Remove objects.
Uncover sensor field