What To Do If - Zanussi ZGL643IT Benutzerinformation

Warning! Do not use abrasive cleaners, steel wool
pads or acids, they can cause damage to the
appliance.
• You can remove the pan supports to easily clean the
hob.
• To clean the enamelled parts, cap and crown, wash it
with warm soapy water.
• Stainless steel parts wash with water, and then dry with
a soft cloth.
• The pan supports are not dishwasher proof; they must
be washed by hand.
• When you wash the pan supports by hand, take care
when you dry them as the enamelling process occa-
sionally leaves rough edges. If necessary, remove
stubborn stains using a paste cleaner.
• Make sure you position the pan supports correctly after
cleaning.
• To make burners work correctly, make sure that the
arms of the pan supports are in the centre of the burn-
er.

What to do if...

Problem
There is no spark when lighting the
gas
The flame is blow out immediately af-
ter ignition
The gas ring burns unevenly
• Be very careful when you replace the pan supports to
After cleaning, dry the appliance with a soft cloth.
Removing the dirt:
1. – Remove immediately: melting plastic, plastic foil,
2. Clean the appliance with a damp cloth and some de-
3. At the end rub the appliance dry with a clean cloth.
Periodic maintenance
Periodically speak your local Service Force Centre to
check the conditions of the gas supply pipe and the pres-
sure adjuster, if fitted.
Possible cause
• There is no electrical supply
• Burner cap and crown are placed
uneven
• Thermocouple is not heated suffi-
cient
• Burner crown is blocked with food
residues
prevent the hob top from damage.
and food containing sugar.
– Stop the appliance and let it cool down before you
clean: limescale rings, water rings, fat stains, shi-
ny metallic discolorations. Use a special cleaner
applicable for surface of hob.
tergent.
• Make sure that the unit is connec-
ted and the electrical supply is
switched on.
• Control the fuse. If the fuse is re-
leased more than one time, refer
to a qualified electrician.
• Make sure that the burner cap and
crown are in correct positions.
• After lightning the flame, keep the
knob pushed for approximately 5
seconds.
• Make sure that the injector is not
blocked and the burner crown is
clear of food particles.
Remedy
21