Technical Data - Mettler Toledo SPC Benutzerhandbuch

2.5 Technical data

Environmental conditions
Compensated temperature range
Operating temperature range
Storage temperature range
Relative air humidity range
Overvoltage category
Pollution degree
Means of protection
IP protection (sensor / electronic unit)
Height above sea level
Electrical connection
Power supply
Further technical data
For further technical data and accessories refer to the SPC Data Sheet.
3 Installation of the SPC weighing system
3.1 Unpacking
Refer to Fig. 1 and Fig. 2 on the front pages.
− Remove the inner packing from the outer one.
Damage to the weight sensor
1 Handle the weight sensor with care. The sensor must not fall over.
2 Mount the foam protection (8) over the weight sensor (1).
3 Ensure that no liquid comes into contact with the weight sensor.
3.2 Mounting
Refer to Fig. 3 to Fig. 6 on the front pages.
Mounting the weight sensor (Fig. 3)
a) Put the weight sensor on a stable surface and use the foam protection if the sensor is not fixed.
b) Mount the weight sensor with 4 screws M3 on a mounting plate.
Mounting the electronic unit (Fig. 4)
Damage to the electronic unit
1 Observe the minimum distances resp. the correct mounting position, see Fig. 4a/4b.
2 Ensure that no liquid comes into contact with the electronic unit.
6
CAUTION
CAUTION
10 °C to 30 °C
5 °C to 40 °C
–20 °C to 70 °C
20 % to 80 %, non-condensing
II
2
III
IP30 / IP20
max. 4000 m
12 to 24 V DC (±10 %), 5 W
•
alternatively
PoE IEEE 802.3af
•