Megasat Campingman WSTA-DP250P Bedienungsanleitung Seite 40

Setting the Skew Angle
If you have determine the correct skew angle, follow the steps below to adjust the antenna's
LNB skew angle.
Caution To avoid bodily injury, be sure to turn off the antenna
and disconnect power to all wored components.
1. Turn off the antenna and disconnect power to all wired components.
2. Using the screwdriver, remove the screws securing the radome. Then remove
and set it aside in a safe place.
3. Locate the LNB assembly on the front of the antenna reflector as
(-) Direction
Caution Be sure to keep the LNB fully inserted into the hall to ensure the
4. Loosen the four screws fastening the LNB.
5. Adjust the LNB clockwise or counter-clockwise, until the LNB center line on
the LNB points to the skew angle that you determined earlier.
6. Tighten the four screws.
7. Reinstall the radome.
LNB Center Line
-
Figure A-3 LNB Skew Angle Adjustment
and the A-2 The Back of the Reflector
optimum performance.
(+) Direction
+
LNB