Installation Cleaning Disposal Warranty And Service; Warranty - LIVARNO LUX IAN 333239_1910 Montage-, Bedienungs- Und Sicherheitshinweise

Mark the drill holes using the holes in the the
light housing intended for the screws
1
a guide.
Now drill the fixing holes. Make sure that you
do not damage the external mains connection
cable .
3
Insert the wall plugs
2
(see Fig. A).
Open the connection box
both screws and removing the connection
6
box cover (see Fig. B).
4
Feed the external mains connection cable
through the designated rubber membrane.
Make sure that the double insulation of the
mains connection cable (external)
at least 8 mm through the rubber membrane
(see Fig. C).
Now connect the individual strands of the
mains connection cable
terminal (see Fig. C).
8
Make sure the colours of the connected lines
match (L or 2 = black or brown, N or 1 = blue
or white). Safety class 2: This light is specially
insulated and must not be connected to a pro-
tective conductor.
Close the connection box
the connection box cover
two screws (see Fig. D).
6
Ensure that the seal is seated correctly, other-
wise IP protection cannot be guaranteed.
Pay attention to the markings in the light hous-
ing (see Fig. E). Only install the light in the
1
direction of the arrow.
Install the light housing
screws (see Fig. F).
9
Put the cover back on the light housing
7
The cover must audibly click into place (see
7
Fig. G).
Replace the fuse or switch on the circuit breaker
(I setting) in the fuse box. Your light is now
ready to use.
Cleaning
RISK OF ELECTRIC SHOCK!
Disconnect the light from the mains circuit before
Installation / Cleaning / Disposal / Warranty and service
as
9
into the drill holes
by loosening
5
3
is pushed
3
with the lustre
3
again by securing
5
in place using the
4
using the designated
1
.
1
cleaning. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (position 0).
Allow the light to cool off completely.
Only use a dry, lint-free cloth for cleaning. Do
not use solvents, spirit or similar substances.
They could damage the light.
Reinstall the fuse or switch on the circuit breaker
in the fuse box (I position).Your light is now
ready to use.
Disposal
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
not in the household waste. Information
on collection points and their opening
hours can be obtained from your local
authority.
Warranty and service

Warranty

You receive a 36 month warranty on this product,
valid from the date of purchase. The appliance has
been carefully produced under strict quality control.
Within the warranty period we shall rectify without
charge all material and manufacturing defects. In
the event of a defect during the warranty period,
please send the appliance to the listed Service
Centre address, referencing the following model
GB/IE 15