GM-Racing Purple SX12 Gebrauchsanleitung Seite 20

SWITCH functions of the SET-button
With this function, you can programm the SET-button as ON-/OFF-SWITCH.
It's also possible to adjust the speed controller to switch off the BEC after holding the transmitter throttle
for about 16 seconds at full brake. With this function you don't need help from anybody to switch off your
car after the heat. The speedo controllers also saves the SWITCH "position" (ON/OFF).
If you plug off the battery with the speed controller ON, it will be ON after pluging in the battery again.
If you plug off the battery with the speed controller OFF, it will be OFF after pluging in the battery, except
of SWITCH function 0, 2 and 6. In this functions, the speed controller can only be switched OFF with the
SET-button, but it will be ON immediately after pluging in the battery.
0 = speed controller allways on, can not be switched OFF with the SET-button or the radio
1 = speed controller can be switched ON and OFF with the SET-button
2 = speed controller on after pluging in the battery, but can be switched off with the SET-button
3 = not defined
4 = speed controller can be switched OFF with 16s "full brake" position of the transmitter throttle trigger
5 = speed controller can be switched ON with the SET-button and can be switched OFF with the SET-
button or 16seconds "full brake" position of the transmitter throttle trigger
6= speed controller is on after pluging in the battery, but can be switched OFF with the SET-button or 16
seconds "full brake" position of the transmitter throttle trigger
To switch the speed controller ON and OFF with the SET-button, just press the SET-button for a short
time.
In the case, your receiver should not show the normal operation after switching ON the speed controller,
just plug OFF the battery for a few seconds and plug IN the battery again to "RESET" the speed
controller and the receiver.
20