Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connection to receiver
GM-Racing speedos are fitted with a Futaba or JR
radio plug. If you use a different radio system you
may have to change the order of the wires to
coincide with your radio equipment.
red
= receiver positive
black or brown
= receiver negative
white or orange
= receiver impulse
ON/OFF-Switch:
Attention! If the speed controller should not work
normally after switching on, switch off and on
again.
Switching ON:
1. Switch on your radio
2. Connect the speed controller to the battery
3. Switch on the speed controller
Switching OFF:
1. Switch off the speed controller
2. Unconnect the battery
3. Switch off the radio
Radio Adjustment
Connect motor and battery to your speedo as described earlier in this manual.
Turn on your transmitter and set all throttle rates to 100%.
Turn on your speedo.
Press the set button for about 4seconds until the red and green LED is on. Do not move the throttle on
your transmitter. After 2 secs the red LED is off (neutral saved). During the green LED is on (red off)the
next 3 secs give full throttle, full brake and then back to neutral on your transmitter.
If you press now the SET-button until the 3 short green LED signals occur, all additional functions are
reset to factory settings.
If you don't want to reset the speed controller, just wait for the confirmation signal of the speedo (three
short green LED signals).
(Turbo=5A, Brkmin=0%, Brkmax=100%, Autobrk=0%, variable Frequency 1-4kHz+ LIM, linear power
curve, 200A current limit and start current, Full Brake=100%, ABS=0=off, Autogas=0, Switch=5.)
The speedo is now tuned to your transmitter.
To check you have tuned it properly, the LED will light at neutral (red and green), full speed and full
brake (red) and half throttle area (green).
If it does not, repeat the above section.
Programmable additional functions:
For progamming the additional functions
with the SET-button, please look for the
program number.
Change order of wires
1
3
Program number
Program
0
IDA-System (RS232)
1
Strombegrenzung
2
maximale Bremse
3
Automatikbremse
4
Gaskurve
5
Frequenz
6
Startstrom
7
Turbo
8
minimale Bremse
9
Vollbremse
10
ABS
11
Autogas
12
Reglerschalterfunkt.
2
17
Werbung
Kapitel
Inhaltsverzeichnis
