Product Description - Korona 57010 Bedienungsanleitung

Product Description

1. Lid with ventilation slots
2. Drying baskets ( x 5)
3. Housing
4. LED Display
5. Timer
6. Temperature setting button
7. + and – button
8. ON/ OFF button
9. Power cord and plug
Temperature Setting
- From 35 °C – 70 °C
(Preset temperature: 35 °C)
- Use the + and – button to increase/decrease the temperature
Timer Setting
- 30 Min to 19 hours
(Preset time: 10 hours)
- Use the + and – button to change the time setting (30 minutes steps)
- Acoustic sound after set time has elapsed
Thermal safety cut-out
The appliance has a thermal safety device. In case of thermostat failure (overheating), the
electrical circuit has an automatic cut-out, thus preventing overheating. If this should happen,
disconnect the appliance from the mains.
Before First Use
• Remove all packaging material and check whether the appliance is complete and
undamaged.
• Do not use the appliance if it shows any signs of damage.
• Fully unwind the power cord.
• Place the appliance on an even and heat resistant surface.
• Connect the appliance to a properly installed wall socket, switch on the appliance and let it
run for 30 minutes at 70°C.
NOTE: When using the appliance for the first time, a slight odour might occur. This doesn't
cause any harm nor does it mean that your appliance does not work properly. Make sure that
the room is well ventilated!
• Afterwards, let the appliance completely cool down and clean it according to "Cleaning and
Care".
After this preheating process, your appliance is ready to be used.
Warning: Plastic bags are a danger to toddlers and babies, therefore keep them away
to avoid suffocation.
18
3
4
7
5
1
2
9
6
8