Before Use - Taurus Alpatec ATACAMA 2001 Bedienungsanleitung

English
FAN HEATER
ATACAMA 2001
DESCRIPTION
A Adjustable thermostat knob
B Function and heat intensity knob
C Pilot light
D Base
E Handle
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
- Fully extend the appliance's power cable before
each use.
- Do not use the appliance if the on/off switch
does not work.
- Do not move the appliance while in use.
- Use the appliance handle, to catch it or move it.
- Do not use the appliance if it is tipped up and do
not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- If you use the appliance in a bathroom or similar
place, unplug the appliance from the mains
when it is not in use, even if it is only for a short
while, as proximity to water involves a risk, even
if the appliance is disconnected.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or redu-
ced mental or lack of experience and knowled-
ge.
- Do not store the appliance if it is still hot.
- Do not store the appliance on areas where the
temperature could be lower than 2ºC.
- Make sure that dust, dirt or other foreign objects
do not block the fan grill on the appliance.
- Never leave the appliance unattended while in
use.
- Never leave the appliance connected and unat-
tended if it is not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance to dry pets or animals.
- Do not use the appliance to dry textiles of any
kind.
- CAUTION: User can't sleep when appliance is
under use; there is a risk of injuries.
- Turning the thermostat control to the minimum
(MIN) setting. This does not mean that the hea-
ter is switched off permanently.
INSTRUCTIONS FOR USE

BEFORE USE:

- Make sure that all products' packaging has
been removed.
- Some parts of the appliance have been lightly
greased. Consequently, the first time the
appliance is used a light smoke may be detec-
ted. After a short time, this smoke will disappear.
- To eliminate the smell given off by the appliance
when used for the first time, it is recommended
to have it on at full power for 2 hours in a well-
ventilated room.
- Prepare the appliance according to the function
you wish to use.
USE:
- Extend the cable completely before plugging it
in.
- Connect the appliance to the mains.
- Turn the appliance on, by turning the adjustable
thermostat knob (A) clockwise until you hear it
'click' (it means the temperature control is on).
- Turn the thermostat control to the desired tem-
perature position.
- The pilot light (C) will turn on, indicating that the
heater is plugged in and turned on. It will con-
tinue to glow even if the thermostat has cycled
the heating elements off to indicate it is still
maintaining the temperature of the room.
- Turn the function and heat intensity knob (B) to
the desired position:
- Low power 1200W
- High power 2000W
- Low power 1200W + oscillation
- High power 2000W + oscillation
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the adjustable thermostat knob (A) coun-
terclockwise to the MIN position.
- Stop the appliance, selecting position 0 on the
function and heat intensity knob (B).