Before Use - Taurus Alpatec BAGNO 2Q Bedienungsanleitung

English
QUARTZ HEATER
BAGNO 2Q
DESCRIPTION
1 Outer shell
2 Front cover grill
3 Quartz tube
4 Pull cord switch
5 Rotary knob
6 Wall mounted bracket
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
- Fully extend the appliance's power cable befo-
re each use.
- Do not use the appliance if the on/off switch
does not work.
- Do not use the appliance if it is tipped up and
do not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- If you use the appliance in a bathroom or simi-
lar place, unplug the appliance from the mains
when it is not in use, even if it is only for a short
while, as proximity to water involves a risk,
even if the appliance is disconnected.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Do not touch the cover of the appliance while
it is in use or during the minutes following the
use, until it cools down.
- Do not store or transport the appliance if it is
still hot.
- Keep the appliance in a dry, dust-free place,
out of direct sunlight.
- Make sure that dust, dirt or other foreign ob-
jects do not block the fan grill on the appliance.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance to dry pets or an-
imals.
- Do not use the appliance to dry textiles of any
kind.
- CAUTION: Do not use the appliance if the
safety grill is cracked or broken.
ASSEMBLING THE WALL
MOUNTED BRACKET:
- The quartz heater must be installed in a hori-
zontal position only. Do not install at the ceiling
or vertically.
- Respect the minimal distances between the de-
vice and the walls, the ground, the furniture etc,
to the ground 180cm at least, to the top 50cm
at least, the left or right side with min 40cm and
40cm frontally. (Fig. 1)
- Place the wall mounted bracket level against
the wall so the holes are parallel. Use a pencil
or marker to mark the hole position. (Fig.2)
- Fix the wall mounted bracket on the rear cover
with the 4 pcs provided screws (Fig. 3)
- Drill holes on the wall with ɸ 8mm drill bit and
insert the plastic wall plugs.
- The degree of wall mounted bracket can be ad-
justed by loosening and fastening the 2 screws
at each side. Before installing the product on
the wall, loosen the screws and make it at the
lowest position.
- Fix the wall mounted bracket (attached with
product) to the wall with the 2 pcs screws pro-
vided. Make sure the wall mounted bracket is in
the correct direction. Fig.4.
INSTRUCTIONS FOR USE

BEFORE USE:

- Make sure that all products' packaging has
been removed.
- Some parts of the appliance have been lightly
greased. Consequently, the first time the ap-
pliance is used a light smoke may be detected.
After a short time, this smoke will disappear.
- To eliminate the smell given off by the applian-
ce when used for the first time, it is recommen-
ded to have it on at full power for 2 hours in a
well-ventilated room.