Taurus Alpatec BAGNO 2Q Bedienungsanleitung Seite 7

- Prepare the appliance according to the function
you wish to use:
USE:
- Extend the cable completely before plugging
it in.
- Connect the appliance to the mains.
- Turn the appliance on, by pulling the switch pull
line or turning the rotatory switch counterclock-
wise.
- Choose the desired power (I or II).
- After a few seconds, depending on the power
selected, one or the two tubes will light up and
will start emitting heat.
- CAUTION: Do not touch the cover of the appli-
ance during the use or the minutes following
the use of the appliance since it could cause
severe burns.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn off the appliance by getting the switch to
the 0 position.
- Unplug the appliance from the mains.
- Let it cool down for a few minutes.
- Clean the appliance.
- The appliance has an anti-tipping safety device
that turns it off if the working position is not the
correct one.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.
- Remark: When the appliance is used as a hea-
ter after long periods in storage or after having
been used solely as a fan a small amount of
smoke may be produced. This is not important
and is due to the heater burning dust de-
posits which have accumulated on the heating
element. This phenomenon may be avoided by
cleaning the inside of the appliance before-
hand through the grill with a vacuum cleaner or
pressurised air.