Balluff BIS C-60 Serie Handbuch Seite 65

C60_1-029_0108_en.p65
53
Opening the
Processor
BIS C-6001
Opening the processor
54
Make connections
on the BIS C-6001
processor
54 E
BIS C-6001
Opening the Processor
The BIS C-6001 processor must be opened to perform the following steps:
– Set/change compatibility mode
– Replace EEPROM
– Make electrical connections (supply voltage, in-/output, I
Be sure that the unit is disconnected from power before
opening.
Remove the 4 screws on the BIS C-6002 and lift off the
cover.
Perform the desired action. To make the electrical connec-
tions, push the cables through the fittings. For additional
wiring details, see the following
Mounting of the cover (4 screws),
max. permissible tightening torque: 0.15 Nm
BIS C-6001
Installing the connection cables
The BIS C-6001 processor must be opened in order to make the connections for the supply
voltage, the digital input and the I
NTER
First be sure that the unit is disconnected from power.
Remove the 4 screws on the BIS C-6001 and lift off the cover.
Guide the two I B cables through the PG 11 fittings (see
NTER US
tion on wiring, see the following
Push the cable for supply voltage and for the digital input through the PG 9 fitting.
Close up the processor.
If the processor is equipped with an adapter:
– BIS C-650: Connect the read/write heads to terminals Head 1 and Head 2.
– BIS C-670: Connect the read/write head to terminal Head 1.
B
NTER US
.
19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1
B connections (see 53).
US
55). For additional informa-
.
connections).
X3
Head 1
Head 2
E 53