Installation; Power Supply; Installing An Antenna; Replacing Fuse - Midland Alan 78 Pro Bedienungsanleitung

INSTALLATION

Safety and convenience are the primary consideration for mounting any piece of
mobile equipment. All controls must be readily available to the operator without
interfering with the movements necessary for safe operation of the vehicle. Set the
proper position in the car to install the transceiver using the supplied supporting
bracket or eventually the slide bracket. Tighten the retaining screws. The fixing
bracket must be close to metallic parts.

POWER SUPPLY

Be sure the transceiver is OFF. In the direct-voltage power supply, it is very
important to observe the polarity even if the unit is protected against the acci-
dental inversion:
Red = positive pole (+)
Black = negative pole (-)
The same colors are present on the battery and in the fuse box of the car. Correctly
connect the cable terminal to the battery.
ATTENTION: To obtain best performances we recommend to install the radio in
a place with enough air circulation.

INSTALLING AN ANTENNA

1.
Place the antenna as high as possible
2. The longer is the antenna, the better will be the performance
3. If possible, mount the antenna in the center of whatever surface you choose
4. Keep antenna cable away from noise sources, such as the ignition switch,
gauges,etc.
5. Make sure you have a solid metal-to-metal ground connection.
6. Prevent cable damage during antenna installation.
WARNING: To avoid damage, never operate your CB radio without connecting a
proper antenna. A periodical control of the cable and of the S.W.R. is recommended.
4

REPLACING FUSE

If you replace the fuse for DC power Cord, use F 2A 250V type. The parameters
and the symbol of the fuse are indicated in the following label.
F2A 250V +
HOW TO OPERATE WITH YOUR
TRANSCEIVER
1. Screw the microphone plug into the microphone jack.
2. Make sure your antenna is securely connected to the antenna connector.
3. Make sure the SQUELCH control is turned fully counterclockwise.
4. Turn on the unit and adjust the volume control.
5. Select your desired channel.
6. To transmit, press the PTT button and speak in a normal tone of voice.
7.
To receive, release the PTT button.