Atag CM4411 Anleitung Seite 141

TROUBLESHOOTING
FAULT
When the "coffee strength/
preground coffee" knob is
turned completely to the left or
right , water comes out of the
machine instead of coffee.
The machine does not swithen
the on/off button is pressed.
The brewing unit cannot be
taken out for cleaning.
CAUSE
The ground coffee could have
got stuck in the fi lling chute.
The main switch on the right
side of the appliance is not
switched on or the mains plug is
not plugged in.
The coffee machine is switched
on. The brewing unit can only
be removed when the machine
is switched off.
Too much preground coffee was
inserted.
SOLUTION
Remove the ground coffee with
the help of a knife (see page
16, fi g 14). Then clean the
brewing unit and the inside of
the machine (see "Cleaning the
brewing unit" on page 21, 22
and 23).
Check that the main switch is
in the I position and that the
power lead is plugged in the
socket properly.
Switch the appliance off and
remove the brewing unit (see
"Cleaning the brewing unit" on
page 21, fi g. 25). IMPORTANT:
The brewing unit can only be
taken out
when the appliance is switched
off. If you try to take out the
brewing unit whilst the coffee
machine is switched on, this
could be seriously damaged.
Remove the brewing unit and
carefully clean the insided of
the machine (see "Cleaning the
coffee machine" and "Cleaning
the brewing unit" on page 21,
22 and 23). Repeat the process
using a maximum of 2 level
measuring spoons of ground
coffee.
EN 33