Atag CM4411 Anleitung Seite 131

MAINTENANCE
30
31
32
33
Notes
• If the brewing unit is not put in place correctly, the service door
cannot be closed.
• If it is diffi cult to insert the brewing unit, it must be made into the
right height (before inserting) by pressing the brewing unit fi rmly
together from top and bottom (fi g. 31).
• If it is still diffi cult to insert the brewing unit:
• Leave it out of the appliance, place the drip tray, close the service
door, switch the the main switch on the back of the appliance to 0
and then to l again.
• Wait for all the lights to go off, then open the door, remove the drip
tray and replace the brewing unit.
• Replace the drip tray, together with the grounds container.
• Close the service door.
Cleaning the nozzles and the milk container
Clean the nozzles on the milk container every time after you heat milk
or make cappuccino (see "Cleaning the nozzles" on page 19). The milk
container must be cleaned regularly.
1. Unfasten the lid of the milk container with a slight turn clockwise
and remove it.
2. Pull off the suction pipe (fi g. 32).
3. Pull off the milk dispenser pipe and the slider on the lid (fi g. 33).
4. Carefully clean all the parts with hot water and detergent.
Do not clean the parts of the milk container in the dishwasher!
Another way of easily cleaning the milk jug:
Fill the milk jug with water and place it in the device. Press the
'Automatic Cappuccino' button twice. Repeat three times.
EN 23