Atag CM4411 Anleitung Seite 120

USE
EN 12
• After the coffee has fi nished dispensing (the progress bar reaches
100%), you can increase the amount of coffee by pressing and
holding the "1 cup" button until the desired amount of coffee is
reached.
• When the display shows the message FILL TANK!, you must fi ll the
tank, otherwise the appliance cannot make any coffee. It is normal
that there is some water left in the water tank when the message is
displayed.
• The appliance counts the number of coffees made. Every 14 single
coffees (or 7 doubles) the appliance displays EMPTY WASTE
COFFEE CONTAINER. This means that the waste coffee container
is full and must be emptied and cleaned. As long as the waste
coffee container is not cleaned, this message remains in place and
the coffee machine cannot make any coffee. To clean, open the
service door at the front by pulling the coffee spout
(fi g. 8), remove the drip tray (fi g. 9), empty it and clean it.
8
9
Important!
Always completely extract the drip tray, to avoid that it falls
when removing the grounds container (fi g. 10). Empty the
grounds container and clean thoroughly, making sure all
residues deposited on the bottom are removed.
Every time you pull the drip tray out, the waste coffee container
must also be emptied, even if it is not completely full. If this
10
process is not carried out, the waste coffee container may
overfi ll when coffee is made and the machine may get blocked.