Atag CM4411 Anleitung Seite 136

MAINTENANCE
EN 28
Rinsing
If 2/3 minutes have passed, since you last made coffee, you should
fi rst rinse the system to preheat the brewing unit. Select the rinsing
function from the appropriate menu. Let the water run into the drip tray
underneath. You can also use this water to warm up the cup that you
are using for the coffee. In this case simply let the hot water run into the
cup (and then empty it).
1. Press the MENU button and press the scrolling buttons < or >
until the menu option RINSING appears. Confi rm the menu option
with the OK button.
2. The appliance performs an automatic rinse cycle (a little hot water
runs out of the spouts and is collected in the drip tray beneath).
Statistics
You can look up the following information values:
• total number of coffees made with the appliance up to that point;
• number of descaling procedures carried out;
• number of cappuccinos made.
2 cups of coffee dispensed at the same time are counted as 2 cups.
Proceed as follows to look up the values:
1. Press the MENU button and press the scrolling buttons < or > until
the menu option STATISTICS appears. Confi rm the menu option
with the OK button.
2. The number of cups dispensed so far appears on the display, e.g.
TOT. COFFEES 135.
3. Repeatedly press the scrolling button > to show the number of
descaling procedures carried out, e.g. TOT. DESCALES 5 and the
number of cappuccino's, e.g. TOT. CAPPUCCINO 135.
Resetting the appliance to factory settings
This function resets previously changed values to the factory settings.
The following settings or saved data are affected:
• water hardness;
• cup fi lling quantities;
• coffee temperature;
• switch-off time.