Troubleshooting; Frequently Asked Questions - Philips HR7775 Bedienungsanleitung

EN
|

Troubleshooting

Problem Solution
The appliance Make sure that all assembly indications (on the lid
does not go on. of the bowl, on the bowl, on the blender jar and
on the motor unit) are aligned.
The appliance The lid of the bowl may have become undone
suddenly stops during a heavy processing job. Close the lid
running. properly. The appliance immediately starts working
again.
The processing job is too heavy. Set the control
knob to OFF to switch off the appliance and
remove the mains plug from the wall socket. Then
let the appliance cool down to room temperature.
Plug in the appliance and switch it on again.
Process smaller batches.
The motor of Please check if you have inserted the tool holder.
the device runs
but cone of the
citrus press
does not turn.
Please check if you have attached the sieve of the
citrus press properly. (Indication on the sieve
points to indication on the handle of the bowl).
Frequently asked questions
Question Answer
Can I clean all Yes, except the motor unit and the protection cap
removable for the blade unit.
parts in the
dishwasher?
Question Answer
What does When you press the Pulse button, the appliance
'pulse' mean? will run at its highest speed a s long you keep
pressing the button. Using the Pulse button is
recommended if you want to have more control
over the processing job, for instance when you are
chopping.
Can I pour No, let the liquids or ingredients cool down to
boiling hot 80°C to avoid damaging the accessories.
ingredients into
the blender jar?
Why does the It is very common for a new appliance to give off
motor produce an unpleasant smell or emit some smoke the first
an unpleasant few times it is used .This phenomenon will stop
smell during after you have used the appliance a number of
processing? times. The appliance may also give off an unpleasant
smell or emit some smoke if it has been used too
long. In that case you have to switch the appliance
off and let it cool down for 60 minutes.
What should I Switch the appliance off and use a spatula to
do when the dislodge the ingredients that block the blade unit.
blade unit or We also recommend processing a smaller quantity.
motor gets
blocked during
processing?
What should I Switch the appliance off and pour out the
do if the ingredients. Then remove the blade unit interface.
blender leaks? Check if the sealing ring has been assembled
properly on the blade unit.
Why does the If you want to use the ice button, first turn the
ice function not control knob to position ON. Then push the ice
work? button.