System Information - Cameo ZENIT Z120 G2 Bedienungsanleitung

SYSTEM INFORMATION

Press MODE to access the selection menu. Use the UP and DOWN controls to select the menu item "System Information" (observe arrow)
and confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
 System Information
Use the UP and DOWN controls to select the desired submenu item, and press ENTER to display the corresponding information.
System Information (bold = factory setting)
Firmware =
Temperature =
Operation Hours =
MANUAL LOCKING FUNCTION
In addition to the ability to automatically protect the lamp from accidental and unauthorised operation (see "Settings" - "Auto-lock"), the
controls can also be locked manually. Press and hold the UP and DOWN controls simultaneously for approximately 5 seconds. If an attempt
is made to change settings, "LOCKED" will appear in the display and it will no longer be possible to change the spotlight's settings via
the controls. After approx. 1 minute, the current operating mode is displayed again. To unlock, press and hold the UP and DOWN controls
simultaneously for approximately 5 seconds. The display will show the previously displayed information.
Displays device firmware
Displays temperature of LED unit
Displays operating time
Main CPU Vx.xx
LED LED TEMP xxxC/xxxF
Celsius/Fahrenheit Unit Celsius (= display in degrees
Celsius)
Unit Fahrenheit (= display in degrees
Fahrenheit)
OpTime xxxx:xxh Displays total operating time in hours
and minutes
11