Flott P23 STE GL Bedienungsanleitung Seite 20

2.2.Operation Type "Thread Cutting without Lead Screw
àBasic setting: Main switch "0". Barrel in basic setting "up". Lower empty lead cartridge (fig.
A). Push drilling depth ring (20) as far out as possible. (Maximum drilling thrust).
àMachine ON: Main switch "1". Barrel in basic setting "up".
à Select Operation Type:
à Choose operating work rpm V
à Set speed for reverse running: Reverse running speed can be selected independent from
the selected operating rpm (0 - 1000 rpm).
Keep pressed and set with
à Set reference point: Change LED-display with
lower the tool onto the work piece and zero with
à Select thread depth:
à Start machine:
When the set depth of the thread is reached the screw spin is reversed electronically by
operating the pedal, or by operating the barrel end switch "down", so that the tool withdraws
automatically from the cut thread. In initial setting of the barrel the sin is reversed again so that
the next thread can be cut.
à Shut machine down:
201271 D/E
E
:
A
the desired number of revolutions.
.
. This value is saved automatically.
to depth display. Use the drilling cross to
19