Klarstein Virtuosa EcoAdapt Handbuch Seite 45

Connecting the Hob to the Mains Power Supply
WARNING
Risk of injury! This hob must be connected to the mains power supply
only by a suitably qualifi ed person.
The power supply should be connected in compliance with the relevant standard, or a
single-pole circuit breaker. The method of connection is shown below.
• If the cable is damaged or needs replacing, this should be done by an after-sales
technician using the proper tools, so as to avoid any accidents.
• If the appliance is being connected directly to the mains supply, an omnipolar
circuit breaker must be installed with a minimum gap of 3 mm between the contacts.
• The installer must ensure that the correct electrical connection has been made and
that it complies with safety regulations.
• The cable must not be bent or compressed.
• The cable must be checked regularly and only replaced by a proper qualifi ed
person.
EN
45