Klarstein Virtuosa EcoAdapt Handbuch Seite 42

EN
42
Note: The safety distance between the hotplate and the cupboard above the hotplate
should be at least 760 mm.
A (mm) B (mm)
760 min. 50
Before Installing the Hob
Make sure that:
• The work surface is square and level, and no structural members interfere with
space requirements.
• The work surface is made of a heat-resistant material.
• If the hob is installed above an oven, the oven has a built-in cooling fan.
• The installation will comply with all clearance requirements and applicable
standards and regulations.
• A suitable isolating switch providing full disconnection from the mains power supply
is incorporated in the permanent wiring mounted and positioned to comply with the
local wiring rules and regulations.
• The isolating switch must be of an approved type and provide a 3 mm air gap
contact separation in all poles (or in all active [phase] conductors if the local wiring
rules allow for this variation of the requirements).
• the isolating switch will be easily accessible to the customer with the hob installed.
• you consult local building authorities and by-laws if in doubt regarding installation.
C (mm) D
min. 20 Air intake
E
Air exit 5 mm