Operation - Cameo ZENIT W300 Bedienungsanleitung

PLEASE NOTE
• As soon as the spotlight is correctly is connected to the power supply, the following will be displayed in succession: "Welcome to Cameo",
the model name and the software version.
After this process, the lamp is ready for operation and starts in the previously enabled mode.
• If one of the DMX operating modes is activated and there is no DMX signal to the DMX input, the currently programmed DMX address is
displayed and the characters on the display will begin to flash.
• After approx. 1 minute, the current operating mode is displayed again.
• Fast Access Feature: In order to simplify the menu guide, the device has an intelligent menu structure that allows direct access to previ-
ously selected menu items and sub-menu items.
1. Press MODE and ENTER simultaneously for direct access to the last-edited sub-menu item, where you can make changes instantly
as required (DMX starting address and all modes).
2. Press MODE for direct access to the last-selected and last-edited menu item. Press ENTER repeatedly to access the sub-menu
items in order to change individual settings (DMX starting address and all modes).
• Before changing device settings, ensure that the control panel is dry and dust free, in order not to impair its functionality.
• The display can be rotated through 180° by pressing UP when the main display is visible.

OPERATION

MAIN DISPLAY
After the power-up process, the lamp is ready for operation and starts in the previously activated mode. The main display appears with the
following information: Current mode (in the example DMX mode) and W-DMX™ status.
W-DMX™
1. To pair with W-DMX™ compatible transmitters, enable W-DMX™ in the device settings (Settings -> Wireless Setting -> W-DMX On Off ->
On) and reset the W-DMX™ module (Receive Reset -> Yes). Start the pairing process as described in the operating instructions of the W-DMX™
transmitter. Pairing is then completed automatically.
2. Connect a group of W-DMX™ devices to create a DMX universe. Disconnect all devices that are supposed to form the group (Settings ->
Wireless Setting -> Receive Reset). Now activate a CLZW300 with a DMX controller via DMX cable and in the settings, select "Transmit"
(Send) (Settings -> Wireless Setting -> Operating Mode -> Transmit). In the settings of the W-DMX™ devices to be controlled via W-DMX™,
select "Receive" (Settings -> Wireless Setting -> Operating Mode -> Receive), pair them and confirm by selecting "Link" (Settings ->
Wireless Setting -> Link -> Link) in the settings of the CLZW300 controlled via DMX cable. Pairing is then completed automatically.
3. It is also possible to create a networked group of W-DMX™ devices via W-DMX™ and to operate them in master/slave mode to use. Disconnect
all devices that are supposed to form the group (Settings -> Wireless Setting -> Receive Reset). Now, in the settings (Settings -> Wireless Setting
-> Operating Mode) of the master unit select "Transmit" (send) and in the settings of the selected slave units, select "Receive". In the master unit,
select the entry "Link" (Settings -> Wireless Setting -> Link -> Link) and confirm by pressing ENTER. Pairing of the devices is then completed
automatically. In the master unit, select one of the standalone modes (Auto, Colour Macro, Static, Tunable White, User Colour) and control the slave
units with it.
6
W-DMX™ status
DMX Address
001
Current operating mode