Cleaning, Maintenance And Spare Parts - EINHELL PROFI Silver Line PS-HKS 1600 Laser Bedienungsanleitung

Anleitung PS-HKS 1600_SPK1
of battery fluid might damage the tool.
Do not place the batteries on heaters or expose
them to direct sunshine for long periods; tempe-
ratures in excess of 50°C may damage the tool.
7.7 Battery disposal
!
iNTERNATiONALES SERViCE CENTER GmbH
Batteries and cordless electric machines and tools
contain materials that are potentially harmful to the envi-
ronment. Never place any cordless electric machines or
tools in your household refuse. When cordless electric
machines or tools become defective or worn, remove the
batteries and return them to iSC GmbH (address:
Eschenstrasse 6, D-94405, Germany). If the batteries
cannot be removed, return the complete cordless machi-
ne or tool. You can then be sure that the equipment will
be correctly disposed of by the manufacturer.
7.8 Laser safety instructions
Achtung
Laserstrahlung
Nicht in den Strahl blicken!
Laserspezifikation
nach EN 60825-1: 1994+A2:2001+A1:2002
Laser Klasse 2 LDBXQ03
P: ≤ 1 mW
Ï: 650 nm
Switch off the marking laser at every opportunity, par-
ticularly if it is not in use, before maintenance and
when you change tools (for example when changing
the saw blade). The laser cannot be repaired, and it
must not be modified in any way.
Important! Laser class 2
Laser radiation is released if the unit has been
opened and is then not closed correctly. Avoid all
direct contact with the beam.
23.08.2005 11:26 Uhr Seite 19
8. CLEANING, MAINTENANCE AND
SPARE PARTS
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
Always pull out the mains power plug before star-
ting any cleaning work.
Clean the tool at regular intervals (remove all
dust, chips, splinters, etc.) We recommend that
you clean the tool immediately after you use it.
Clean the tool with a damp cloth and some soft
soap. Do not use cleaning agents or solvents;
these may be aggressive to the tool's plastic
parts. Ensure that no water can get into the interi-
or of the tool.
8.2 Maintenance
There are no parts inside the tool which require
maintenance.
8.3 Replacing the carbon brushes
Important! The carbon brushes should not be
replaced by anyone but a qualified electrician.
8.4 Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of tool
Article number of the tool
ID number of the tool
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
GB
19