Final Steps - Privileg SY-6010BS-P1-C83-L41-600 Gebrauchsanleitung

Page EN-14 Assembly
9. Mark the mounting holes below the key-
hole openings with a pencil.
10. Remove the exhaust hood again.
11. Drill holes at the marked points using
a diameter that can accommodate the
dowels.
12. Place the dowels into the holes.
13. Hang the exhaust hood again.
14. Secure it by screwing in the lower fixing
screws.
15. If necessary, tighten the upper screws.
Wall mounting is now complete.

Final steps

WARNING
Risk of electric shock!
Never use a damaged appliance.
(14)
1. Turn the switch (14) towards
wards the light.
2. The exhaust hood is delivered with a
pre-inserted fleece grease filter (6). This
is located on the inside of the metal
grease filter (2). If the fleece grease filter
has slipped or fallen out, affix it in place
again.
3. Re-insert the metal grease filter (2) and
secure it in place with the sliders.
4. Connect the mains plug to a properly in-
stalled socket.
The exhaust hood is now ready to use.
(2) (6)
or to-
(2)