Privileg SY-6010BS-P1-C83-L41-600 Gebrauchsanleitung Seite 33

For wall mounting you will need:
– 4 round-head screws (10) with washers,
maximum ø 6 mm,
– 4 suitable dowels,
– Drill with stone bit, correctly sized for the
screws (10),
– screwdriver,
– measuring tape/ruler,
– level,
– pencil,
– stable stepladder,
– a second person to help,
– work gloves.
Determining the drill holes
(13)
Calculating drill holes
(11) Minimum distance between
the hob and lower edge of
exhaust hood
(12) Distance between lower
edge of exhaust hood and
upper fixing lugs
(13) Distance between the fixing
screws
1. Remove the metal grease filter (2) and
2. In order to place the appliance exactly
(12)
3 2 1 0 1 0
(11)
3. Draw the two drill holes for the keyhole
Di-
men-
sions
4. Drill holes at the marked points using a
in cm
70 - 80
5. Place the dowels into the holes.
6. Screw the round-head screw into the
7.5
7. Hang the exhaust hood.
50
8. Check the horizontal position of the ex-
Assembly
carefully put it aside.
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line
on the wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
stovetop.
openings on the wall according to the di-
agram in the left column. Pay attention to
the height information (11) and (12), the
distance between the fixing screws (13)
and the horizontal alignment.
diameter that can accommodate the dow-
els.
dowels until they are firmly seated. There
must be enough space to hang the ex-
haust hood.
haust hood.
Page EN-13
(2)