Controller Parameters - Grundfos Conex DIA-2Q Bedienungsanleitung

11.6.2 Setting the controller parameters
1. Select a controller in the "setup" menu and
configure it.
See section

11.5.5 Controller parameters

2. Select the line "controller" in "main menu" using
the [Up] and [Down] buttons, and press [OK] to
switch to the "controller" menu.
See section 11.4 Main menu.
The "controller" option in "main menu" is
Note
only available if a controller has been
selected in the "setup" menu!
The options available in the "controller" submenu
(main menu) correspond to the configuration made in
the "setup" menu.
1. Use the [Up] and [Down] buttons to change
internal setpoints within the selected measuring
range.
See section 8.4 Measuring
2. Select the displayed controller parameters using
the [Up] and [Down] buttons, press [OK] to switch
to the desired submenu, and use the [Up] and
[Down] buttons to adjust the setpoints as needed
within the permitted ranges.
See section 8.3 Electronic data and
main menu
controller
parameter 1/2
proport. contrl
interpulse ctrl.
int.pulse period
Min. ON time
constant load
max. dosing flow
dosing coeffic.
stop
Fig. 31 Settings for proportional controllers
38
1/2.
ranges.
functions.
settings in the setup menu
proport. contrl
pulse freq. contrl.
max. frequency
constant load
max. dosing flow
dosing coeffic.
stop
proport. contrl
cont. controller
constant load
max. dosing flow
dosing coeffic.
stop